This does not indicate that your collar is not working only that you do not hear it.
Underground fence collar not working.
What can go wrong with an invisible fence.
Because they use a hidden wire that transmits a signal to a collar worn by.
Dogs put up with the shock when the reward is great enough.
Our underground dog fence is not working.
An invisible fence is less expensive than traditional fences because you don t have to buy materials or hire someone to build the fence.
However if your invisible fence stops working you may have to call the company to troubleshoot.
If the test light flashes your collar is working and you should try check the following.
The dog wears a collar that contains a receiver.
April 11 2011 at 2 21 pm wire wrapped around a 1 2 inch cylinder.
Chances are your dog hears it just fine.
The power light is on the loop indicator light is off and the fence transmitter loop alarm is sounding.
Check the fit of the receiver collar on your pet.
Take the test light tool and place it on the receiver collar and walk out to the boundary of the containment system.
As a veterinarian i ve observed five common problems associated with invisible fences.
That can be expensive.
Try troubleshooting problems with your invisible fence yourself.
The collar does not beep or shock.
If your receiver collar is not beeping or correcting your dog.
We have gotten calls that the collar is not working because the dog is not crying or whimpering when he gets too near the fence.
You ll need to diagnose which part or more is not working.
Even at the highest settings the shock collar will not always stop highly motivated dogs from running past the boundary.
There are three components to dog fencing.
At invisible fence brand we welcome your questions.
This is not a fool proof evidence that the fence is not working.
The transmitter gets plugged into this and the wiring from outside to the transmitter goes through.
What to do if an invisible fence is not working.
When the dog approaches the underground pet fence a warning beep goes off.
The collar receiver is beeping but the dog is not responding to the stimulation.
Make sure the static correction level on the receiver collar is set at 2 or above.
The collar has to be held on top of the boundary wire to activate or it does not activate at the boundary at all.
I ve how do you detect a break in an invisible fence.
Troubleshooting your petsafe radio fence includes testing each of its components including the collar the boundary width the transmitter the underground wires and other electrical fixtures that can cause interference with your system.